Forming and cutting torch

Forming and cutting torch at the bottom of steel cylinder

The steel cylinder bottom forming cutting torch SUT-SPC-A-300 matched with the spinning machine is water-cooled to cool the cutting torch body and cutting nozzle, so as to ensure the safe use of the cutting torch in the high heat environment and reduce the risk of high temperature.

With the use of equal pressure quick cutting nozzle ACID, the workpiece with thickness less than 130mm can be perforated.

The shape and size of the cutting torch can be adjusted according to the working conditions on site. The inlet pipe is connected by thread. The air supply can be controlled by the remote solenoid valve. It is recommended to install the regulator and  pressure gauge at the near end of the cutting torch to manually adjust and observe the gas output to achieve the best perforation effect. Please refer to relevant cutting nozzle data for specific parameters.

The equal pressure quick cutting nozzle ACID uses acetylene as fuel gas, which can cut workpieces with a thickness of 3-300mm, and the perforation thickness can reach 130mm.